Garage door spring replacement swaps a broken spring for a new one matched to the door's size and weight. The spring counterbalances the door so the opener does not have to lift it, and once a spring breaks it is replaced, not adjusted or patched. Dallas Metro Garage Door offers spring replacement for homeowners and property managers in Dallas-Fort Worth.

Why the spring, not the opener, lifts the door

A garage door spring counterbalances the door. The spring stores energy as the door closes and gives it back as the door opens. That is why a heavy door can move by hand or with a small motor. The opener only guides a balanced door. It is not built to carry the full weight, and once a spring breaks, that balance is gone.

What spring replacement includes

Spring replacement means taking out the failed spring and fitting a new one matched to your door. The connected parts matter too. Lift cables run from the spring hardware to the bottom of the door, and rollers carry the door along its tracks.

When a spring snaps, a cable can go slack or slip off its drum, the grooved wheel the cable winds onto. A door that dropped unevenly can also push rollers out of line. Because cables and rollers share the load with the spring, their condition belongs in the same conversation. Dallas Metro Garage Door also offers cable and roller service if those parts need attention.

Is it the spring, the opener, or the track?

A spring failure usually shows up in one of these ways:

  • A single loud bang from the garage, often when nobody was using the door
  • A torsion spring, the coiled spring on the bar above the door, with a visible gap splitting the coil
  • An extension spring, the long spring beside the overhead track, hanging loose or stretched out
  • The opener hums or strains, and the door rises a few inches, then stops or reverses
  • The door felt far heavier than usual the last time someone lifted it

Other faults look different. An opener that makes no sound and ignores the remotes and wall button points to the opener itself. A door sitting crooked, with rollers out of the track or one side grinding, points to the track and roller hardware.

Treat these signs as things to describe on the phone, not tests to run on a door that still has parts under tension.

Torsion or extension, one spring or two

Torsion springs mount on a shaft above the door opening and twist to store energy. Extension springs run along the horizontal tracks and stretch as the door closes. Both types counterbalance the door, but they are not interchangeable.

Many doors use two springs that share the load. Both springs have made the same trips, so when one breaks, the other has the same wear behind it. That is why paired springs are often replaced together.

The spring also has to match the door. Height, width, and weight decide how much force the spring needs, and an insulated or wood door asks more than a light single-layer one. A spring that is too weak leaves the door heavy and the opener laboring. One that is too strong can let the door drift up on its own. A generic part chosen by looks can cause either problem.

What to do with the door while you wait

Leave the door where it stopped. Don't run the opener again to test it, and don't force the door up by hand. Without the spring, the door carries its full weight and can come down hard. Keep people, pets, and vehicles out from under it.

The springs, cables, and the bar above the door can stay under high tension after a break, so they are not parts to handle yourself. If the door is stuck closed with a vehicle you need, or stuck open and leaving the garage unsecured, emergency garage door service is the better call.

What to have ready when you call

A few details make the first conversation useful:

  • Door size, and whether it is a single or double door
  • One spring or two, above the door or along the tracks
  • What you heard or saw, such as a bang, a gap in a coil, or a slack cable
  • Whether the door is stuck closed, stuck open, or partway

To book spring replacement or talk through what you're seeing, call Dallas Metro Garage Door at (469) 491-7394. Hours are daily, 9AM to 9PM.

Frequently asked questions

Can I open my garage door manually after the spring breaks?

Opening a garage door by hand after a spring breaks is risky. The spring normally carries most of the door's weight, so lifting the door means taking the whole load, and a slipped grip can let it fall. The opener's release cord disconnects the door from the opener, so pulling it on a door that is partway open can let the door drop.

Does a broken spring damage the opener?

A broken spring can lead to opener damage if the opener keeps running. A garage door opener's motor and gears are made to move a balanced door. Repeated attempts to lift the full weight strain those parts and can bend the arm connecting the opener to the door. Stopping after the first failed try limits that strain.

Is it a problem if only one of two springs has broken?

Yes, one broken spring on a two-spring garage door is still a problem. The remaining spring cannot balance the door alone, so the door stays heavy and can lift unevenly, pulling harder on one cable. The door can seem to work with the opener, but running it that way loads the last spring, the cables, and the opener.

Does a property manager need to give any special information when requesting spring replacement for a unit?

A property manager requesting garage door spring replacement for a unit should share the unit address, how to reach the garage, and who can let someone in. It also helps to say whether a tenant or a vehicle is inside and whether the door is stuck closed or open.

All services