A garage door bottom seal and weatherstripping are two separate parts. The bottom seal is the flexible strip fastened along the door's lower edge, and it presses against the floor when the door closes. Weatherstripping usually means the strips around the sides and top of the opening, where the closed door rests against the frame. Product names vary, so the surest way to tell them apart is by location.
Two seals, two places on the door
Stand inside the garage with the door closed and look at its edges. Along the bottom, a flexible strip runs the full width of the door and presses against the floor. That strip is the bottom seal. It is attached to the door, so it travels up and down with the door.
Across the top and down both sides, many doors have a strip fastened to the frame around the opening, with a soft edge that the face of the closed door rests against. That is the perimeter weatherstripping. It stays on the frame while the door moves past it.
The names are not used consistently. Some sellers call the bottom piece a bottom weatherstrip, and some people call everything weatherstripping. Location settles it: the floor edge is the bottom seal, and the sides and top are the perimeter strips.
What the bottom seal does at the floor
A garage floor is seldom perfectly flat across the opening, while the door's bottom edge is straight. The bottom seal makes up the difference. Because the strip is soft, it squashes more where the floor sits high and less where it dips, which helps limit drafts, blowing debris, water, and pests at that edge.
That same contact is why the bottom seal wears. It is pressed into the floor when the door closes and holds the weight of the door's edge for as long as the door stays shut. Over time the strip flattens and stops springing back, cracks, tears at the ends, or works loose from whatever holds it.
A worn bottom seal also changes how the door meets the floor. The seal touches down first, so when it is flattened or missing in places, a gap can remain at the floor even though the door looks fully closed.
What the side and top weatherstripping does
The side and top strips close the narrow gap between the face of the closed door and the frame. Light or drafts getting past the door at the sides or across the header, which is the top of the opening, point to these strips rather than the bottom seal.
Perimeter strips never carry the door's weight, so they wear differently. They tend to harden, split, or shift on the frame until they no longer meet the door, and the left, right, and top runs can each wear on their own. A cracked bottom seal says nothing about the side strips, and sound side strips say nothing about the floor edge.
Why one name for every strip causes trouble
Treating weatherstripping as one catch-all part makes a description vague. Report that the weatherstripping is bad when the problem is a torn strip at the floor, and whoever hears it has to guess which edge you mean.
The other half of the mix-up is assuming any gap means a seal failed. If the door hangs lower on one side, its bottom edge meets the floor at an angle and light shows at the high end even with a healthy seal. A door sitting slightly away from the frame leaves a gap beside a side strip that is in fine shape. Uneven sitting like that points toward the cables, rollers, or track, which makes it a repair question rather than a seal one.
Light between the door's horizontal panels is a separate case. It comes from the joints between sections and belongs to neither seal.
What to look at, and how to describe it
With the door closed, look from inside in daytime with the garage lights off, and note what you see by location:
- Bottom edge: where light shows along the width (left end, right end, middle, or all the way across) and whether the strip looks flattened, cracked, torn, or loose.
- Sides: whether light shows on the left, the right, or both, and whether it runs the full height or sits in one spot.
- Top: whether light shows across the header and whether the strip there is split or pulled away.
- The door itself: whether the bottom edge looks level against the floor or one side sits higher.
Look and take notes, nothing more. Leave the strips in place, and do not adjust the door or touch the springs, cables, or other hardware.
A note like 'light along the right third of the bottom, strip flattened there, sides look fine' gives a technician a clear starting point. To describe what you found, call Dallas Metro Garage Door at (469) 491-7394, daily from 9AM to 9PM.
Frequently asked questions
Can I see daylight under my garage door even when it is fully closed?
Yes. Daylight under a fully closed garage door means the bottom seal is not touching the floor somewhere along its width. The shape of the light helps narrow it down. A wedge that widens toward one end suggests the door sits unevenly. A short patch in one spot often matches a dip in the floor or a torn piece of strip. A thin line across the whole width usually means the seal has flattened along its length.
Do the side and top strips wear out the same way as the bottom seal?
No. Side and top weatherstripping on a garage door changes mostly with age and exposure rather than with each closing. A stiffened side strip often shows as a thin, even line of light along its length, while a strip that has shifted on the frame leaves a wider gap in one stretch.
All articles