A visible gap in a garage door spring generally means the spring has broken into two pieces. Stop using the door right away, including the wall button, the remote, and the manual release cord. The spring carries most of the door's weight, so once it separates the door is no longer balanced and can drop or bind. Keep people and cars out of the door's path.
Why a separated spring means the door stays put
The spring above a garage door does the lifting. On many doors this is a torsion spring, a tightly wound coil on a metal bar across the top of the opening. The spring winds up as the door closes and gives that stored force back as the door opens. A gap in the coil means that force is gone, and the door's full weight now rests on whatever else is holding it.
Running the opener does not get around this. An opener is built to move a balanced door, not to haul dead weight, so pressing the button can strain the motor or pull the door crooked. The manual release cord carries a different risk. Pulling it disconnects the door from the opener, and the nearest person becomes the only thing holding the door up. Leave both alone.
What to note without touching anything
Look from the floor, off to the side rather than under the door. Keep your hands off the spring, the cables, the brackets at the bottom corners, and the bottom edge of the door. Everything worth noting can be seen from a few steps back.
- Where the gap sits: near the middle of the bar, closer to one end, or on a spring running along one of the side tracks.
- How many springs the door has, and whether each one still looks like a single unbroken coil.
- How the door rests: fully closed and level, closed but lower on one side, or stopped partway up.
- Whether a cable hangs loose or has slipped off the grooved wheel at the end of the spring bar.
- What happened before you noticed: a loud bang from the garage, or the opener humming while the door barely moved.
If you pressed the button before you spotted the gap, write down what the door did. Do not press it again to check.
How a broken spring looks next to a normal one
A clean break versus coils that only look spaced
A torsion spring normally looks like a solid tube of coils sitting tight against each other. A distinct split in that tube, often with the two ends sitting slightly apart, usually means a break. Extension springs work differently. They run along the sides above the horizontal tracks and stretch open while the door is closed, so evenly spaced coils along their whole length are normal. What matters on an extension spring is one spot that looks unlike the rest, or a spring hanging loose.
One of two springs separated
A door with two springs can look almost normal when only one breaks. The clue is often the door itself: one side resting lower than the other, or a gap you only notice once you count both springs.
Closed door versus a door stuck partway
A door resting flat on the floor is the calmer case, because nothing is holding it up. A door stopped partway is being held by friction, a bent track, or a strained cable, and any of those can let go. Stay out from under it.
None of these observations confirms the cause. Only a technician looking at the door in person can do that. A spring that looks whole also does not prove the door is safe if it slammed, stalled, or sat crooked, since a cable or another part can produce the same behavior.
Turning your notes into a clear phone call
Leave the door where it is, keep children and cars away from it, and write your notes down before you call. A description read aloud like this gives a technician a useful picture:
- The door has two springs on a bar above the opening, and the one near the left end has a gap in it.
- The door is fully closed but sits lower on the right side.
- I heard a bang from the garage this morning and have not used the door since.
- No cables look loose from where I stood.
In Dallas-Fort Worth, you can call Dallas Metro Garage Door at (469) 491-7394, any day from 9AM to 9PM, and ask about spring replacement. If the door is stuck open and the garage cannot be closed or secured, say that first and ask about emergency garage door service.
Frequently asked questions
Can I close the door by hand if the spring has a gap?
Closing a garage door by hand after a spring breaks is not a safe move. Without the spring, nothing offsets the door's weight, so lifting or lowering it puts that full load on your hands and back, and the door can drop faster than you can control. If the door is closed, leave it there. If it is stuck open, stay clear and get help.
Should I take a photo of the spring, and from where?
A photo of a broken garage door spring helps, as long as you take it from the floor. Stand to the side of the door rather than under it, and zoom in instead of stepping closer or climbing a ladder near the spring bar. One wide shot of the whole door and one closer shot of the gap show both the door's position and where the coil split.
If one of two springs looks intact, is the door still usable?
A garage door with one broken spring out of two is not usable, even if the other spring looks fine. The door was balanced on both springs working together, and an intact-looking spring tells you nothing about how it will handle the extra load. Running the door can twist it, leave it crooked, or strain the opener.
What if the door is stuck open and I cannot secure the garage?
A garage door stuck open with a broken spring should be left exactly where it is. Do not try to pull it down or disconnect it from the opener. Keep people, pets, and vehicles out of the doorway and out from under the door, and move anything you need out of the garage only if you can reach it without passing beneath the door.
All articles